Routing and Switching MCQs with Answers
Practice important Routing and Switching MCQs with answers and explanations.
Multiple Choice Questions
Q1681: What does SVI stand for in the context of switch management?
- A: Switched Virtual Interface
- B: Static Virtual Interface
- C: Standard Virtual Interface
- D: Secondary Virtual Interface
View Answer
A
Q1682: Fill in the blank: To configure a management interface, you use the _______ command followed by the IP address and subnet mask.
- A: ip address
- B: vlan id
- C: interface
- D: switchport
View Answer
A
Q1683: What is the purpose of configuring a default gateway on a switch?
- A: To manage remote access from networks not directly connected
- B: To increase the speed of the switch
- C: To configure VLAN settings
- D: To backup the configuration
View Answer
A
Q1684: Fill in the blank: The command to back up your switch configuration is _______.
- A: copy running-config startup-config
- B: write memory
- C: save config
- D: backup running-config
View Answer
A
Q1685: What command is used to verify the status of both physical and virtual interfaces?
- A: show ip interface brief
- B: show running-config
- C: show vlan brief
- D: show interfaces status
View Answer
A
Q1686: What does full-duplex communication allow in a switched LAN?
- A: Simultaneous transmission and reception of data
- B: Only transmission of data
- C: Only reception of data
- D: Single-direction communication
View Answer
A
Q1687: Fill in the blank: Full-duplex communication is also known as _______.
- A: Bidirectional
- B: Unidirectional
- C: Half-duplex
- D: Sequential
View Answer
A
Q1688: What is a major disadvantage of half-duplex communication?
- A: Collisions can occur
- B: Simultaneous data flow
- C: Increased bandwidth
- D: No need for micro-segmentation
View Answer
A
Q1689: Fill in the blank: In full-duplex mode, the collision detection circuit on the NIC is _______.
- A: Disabled
- B: Enabled
- C: Ignored
- D: Reduced
View Answer
A
Q1690: What command is used to manually specify the duplex mode for a switch port?
- A: duplex
- B: speed
- C: auto-negotiation
- D: set-duplex
View Answer
A