Skip to main content

Routing and Switching MCQs with Answers

Practice important Routing and Switching MCQs with answers and explanations.

Multiple Choice Questions

Q1131: Which command gives a summary of all OSPF-enabled interfaces?
  • A: show ip ospf summary
  • B: show ip ospf interface brief
  • C: show ip route summary
  • D: show ospf interface
View Answer
B

Q1132: What does the OSPF "Neighbor ID" represent?
  • A: Interface address
  • B: Router ID of the neighboring router
  • C: IP address of the interface
  • D: DR/BDR status
View Answer
B

Q1133: Which factor does NOT prevent OSPF adjacencies from forming?
  • A: Mismatched subnet masks
  • B: Mismatched network types
  • C: Missing or incorrect OSPF network command
  • D: Correct Dead Timer settings
View Answer
D

Q1134: Fill in the blank: OSPF adjacencies are formed over the ____ interface of the router.
  • A: GigabitEthernet
  • B: Loopback
  • C: Serial
  • D: Directly connected
View Answer
D

Q1135: Fill in the blank: The command "show ip ospf ____" provides a detailed list of OSPF-enabled interfaces.
  • A: routes
  • B: neighbors
  • C: interface
  • D: timers
View Answer
C

Q1136: What is the primary difference between OSPFv2 and OSPFv3?
  • A: OSPFv2 uses IPv4, OSPFv3 uses IPv6
  • B: OSPFv2 uses IPv6, OSPFv3 uses IPv4
  • C: OSPFv2 and OSPFv3 use different routing algorithms
  • D: OSPFv2 uses different packet types than OSPFv3
View Answer
A

Q1137: Fill in the blank: OSPFv3 uses ____ addresses to form neighbor adjacencies instead of global unicast addresses.
  • A: link-local
  • B: global unicast
  • C: private
  • D: multicast
View Answer
A

Q1138: What command is used to configure the router ID in OSPF?
  • A: router ospf
  • B: ospf router-id
  • C: ip ospf cost
  • D: ospf configuration
View Answer
B

Q1139: Fill in the blank: The OSPFv2 multicast address used for all OSPF routers is _____.
  • A: 224.0.0.5
  • B: FF02::5
  • C: 239.0.0.5
  • D: 255.255.255.255
View Answer
A

Q1140: Which protocol uses the link-local address of the exit interface as the source address for its messages?
  • A: OSPFv2
  • B: OSPFv3
  • C: BGP
  • D: EIGRP
View Answer
B

Test Your Knowledge

Take a timed quiz on Routing and Switching

🚀 Start Quiz Now