Routing and Switching MCQs with Answers
Practice important Routing and Switching MCQs with answers and explanations.
Multiple Choice Questions
Q881: Fill in the blank: RIPv2 uses _______ to avoid summarizing networks to their classful address at boundary routers.
- A: automatic summarization
- B: no auto-summary
- C: VLSM
- D: CIDR
View Answer
B
Q882: What is the purpose of the passive-interface command in RIPv2 configuration?
- A: To stop routing updates on a specified interface
- B: To enable routing updates on all interfaces
- C: To configure static routes on the interface
- D: To adjust routing protocol metrics
View Answer
A
Q883: Fill in the blank: The passive-interface command in RIPv2 prevents routing updates from being sent out ________.
- A: any interface
- B: all interfaces
- C: a specified interface
- D: directly connected networks
View Answer
C
Q884: What type of route does a default route represent in RIPv2 configuration?
- A: A route to a specific destination
- B: A route to the next-hop router
- C: A route to an unspecified destination
- D: A route that dynamically changes
View Answer
C
Q885: Fill in the blank: To propagate a default route in RIPv2, you must configure a default ________ and use the command default-information originate.
- A: static route
- B: dynamic route
- C: gateway route
- D: network route
View Answer
A
Q886: What is the effect of the command default-information originate in RIPv2?
- A: It advertises the default static route to other routers
- B: It creates a new static route in the routing table
- C: It disables the default route in the routing updates
- D: It limits the routing updates to specific interfaces
View Answer
A
Q887: Fill in the blank: In RIPv2, the command show ip protocols is used to check the status of ________.
- A: routing protocols
- B: IP addresses
- C: network interfaces
- D: static routes
View Answer
A
Q888: What does the show ip route command display in a RIPv2 configuration?
- A: The routing table
- B: The IP address configuration
- C: The static routes
- D: The network topology
View Answer
A
Q889: What is the focus of Topic 79 in Packet Tracer?
- A: Configuring RIPv2-3
- B: Configuring network security
- C: Configuring static routes
- D: Configuring IP addressing
View Answer
A
Q890: Fill in the blank: In Packet Tracer, RIPv2-3 configuration builds upon the knowledge from RIPv2-______.
- A: 1
- B: 2
- C: 3
- D: 4
View Answer
B