Routing and Switching MCQs with Answers
Practice important Routing and Switching MCQs with answers and explanations.
Multiple Choice Questions
Q591: What is the purpose of configuring IP addresses on devices?
- A: To enable data encryption
- B: To ensure devices can communicate
- C: To set device names
- D: To configure device time
View Answer
B
Q592: What should be checked to confirm that a switch is properly configured for remote management?
- A: Connectivity to the router
- B: IP address and access credentials
- C: Console cable connection
- D: Firmware version
View Answer
B
Q593: Fill in the blank: After configuring devices, you should use _______ commands to gather network information.
- A: show
- B: debug
- C: ping
- D: traceroute
View Answer
A
Q594: Which of the following commands would you use to view the IP address assigned to a router's interface?
- A: show ip address
- B: show ip interface brief
- C: show interfaces status
- D: show ip routing table
View Answer
B
Q595: Fill in the blank: To verify that all devices are connected and operational, you should use _______ commands.
- A: diagnostic
- B: show
- C: configuration
- D: setup
View Answer
B
Q596: What type of command is show running-config?
- A: Diagnostic
- B: Configuration
- C: Network utility
- D: Device setup
View Answer
B
Q597: Which of the following is NOT typically included in the basic configuration of a router?
- A: IP addressing
- B: Routing protocols
- C: Security settings
- D: Interface speed
View Answer
C
Q598: Fill in the blank: To ensure remote management, a switch must be configured with a _______ IP address.
- A: static
- B: dynamic
- C: public
- D: private
View Answer
A
Q599: What is the primary focus of Topic 53 in Packet Tracer?
- A: Setting up a basic network
- B: Advanced network troubleshooting
- C: Building a switch and router network
- D: Configuring security settings
View Answer
C
Q600: When continuing from the previous topic, what additional step is typically required?
- A: Adding more devices
- B: Changing IP addressing
- C: Verifying connectivity
- D: Re-configuring devices
View Answer
C