Routing and Switching MCQs with Answers
Practice important Routing and Switching MCQs with answers and explanations.
Multiple Choice Questions
Q551: Fill in the blank: Static routes must be manually _______ when network topology changes.
- A: updated
- B: verified
- C: saved
- D: cleared
View Answer
A
Q552: What is the main purpose of using the "show commands" in a network device?
- A: To configure network settings
- B: To display the current configuration
- C: To reboot the device
- D: To back up the configuration
View Answer
B
Q553: Which of the following is a dynamic routing protocol?
- A: OSPF
- B: DHCP
- C: NAT
- D: ARP
View Answer
A
Q554: Fill in the blank: A ______ route is manually configured to connect to a specific network in a static routing setup.
- A: default
- B: static
- C: dynamic
- D: connected
View Answer
B
Q555: Which command is used to display the current configuration of a router?
- A: show ip route
- B: show running-config
- C: show version
- D: show interfaces
View Answer
B
Q556: What information is typically displayed by the "show ip interface brief" command?
- A: IP address and subnet mask
- B: Routing table
- C: MAC address
- D: DNS server configuration
View Answer
A
Q557: Fill in the blank: The command ______ is used to verify the configuration of an Ethernet interface on a router.
- A: show ip route
- B: show interfaces
- C: show running-config
- D: show startup-config
View Answer
B
Q558: What is the purpose of configuring Ethernet interfaces on a router?
- A: To enable routing between VLANs
- B: To configure dynamic routing
- C: To assign an IP address for LAN communication
- D: To configure DNS resolution
View Answer
C
Q559: Which command would you use to verify the status of a router's interfaces?
- A: show interfaces
- B: show ip route
- C: show version
- D: show arp
View Answer
A
Q560: Fill in the blank: After configuring router interfaces, administrators should use the ______ command to verify the changes.
- A: show ip route
- B: show version
- C: show interfaces
- D: show startup-config
View Answer
C