Routing and Switching MCQs with Answers
Practice important Routing and Switching MCQs with answers and explanations.
Multiple Choice Questions
Q521: Which routing protocol does not rely on manual configuration for network discovery?
- A: Static routing
- B: Dynamic routing
- C: Local routing
- D: Direct routing
View Answer
B
Q522: Fill in the blank: The two route source codes for directly connected interfaces are ___ and ___.
- A: S, O
- B: C, L
- C: D, O
- D: C, S
View Answer
B
Q523: What does the 'S' code in the routing table represent?
- A: Static route
- B: Dynamic route
- C: Local route
- D: Connected route
View Answer
A
Q524: Which protocol is considered a dynamic routing protocol?
- A: OSPF
- B: Default static route
- C: Static route
- D: Local route
View Answer
A
Q525: Which routing protocol is known for its interior gateway routing capabilities?
- A: RIP
- B: EIGRP
- C: BGP
- D: IS-IS
View Answer
B
Q526: What does the default static route specify?
- A: The route to the nearest router
- B: The exit point when no specific route exists
- C: The route to the central router
- D: The IP address of the router
View Answer
B
Q527: Which device is configured for remote management in this activity?
- A: Router
- B: Switch
- C: PC
- D: Firewall
View Answer
B
Q528: What is one of the first steps in configuring a router?
- A: Setting the clock
- B: Assigning IP addresses
- C: Updating the router
- D: Configuring DNS
View Answer
B
Q529: Fill in the blank: After configuring devices, _____ commands can be used to verify network connectivity.
- A: show
- B: run
- C: verify
- D: ping
View Answer
A
Q530: Which command is used to gather information about a router's current configuration?
- A: show running-config
- B: ping
- C: trace
- D: show ip address
View Answer
A