Skip to main content

Routing and Switching MCQs with Answers

Practice important Routing and Switching MCQs with answers and explanations.

Multiple Choice Questions

Q491: Fill in the blank: If multiple paths to the same network exist, the router uses _______ to forward packets equally along each path.
  • A: unequal cost load balancing
  • B: metric value
  • C: equal cost load balancing
  • D: direct connection
View Answer
C

Q492: What happens if two or more paths with equal cost metrics exist in the routing table?
  • A: The router selects one path randomly
  • B: The router drops the packet
  • C: The router forwards the packet using both paths
  • D: The router ignores the paths
View Answer
C

Q493: Fill in the blank: A routing table contains a single destination network but multiple _______ for each equal cost path.
  • A: gateways
  • B: routes
  • C: exit interfaces
  • D: metrics
View Answer
C

Q494: Which routing protocol supports unequal cost load balancing?
  • A: OSPF
  • B: RIP
  • C: EIGRP
  • D: IS-IS
View Answer
C

Q495: Which metric does OSPF use to determine the best path to a destination network?
  • A: Hop count
  • B: Bandwidth
  • C: Delay
  • D: Cost based on cumulative bandwidth
View Answer
D

Q496: Fill in the blank: Load balancing can improve network performance by distributing packets across _______.
  • A: a single path
  • B: multiple paths with equal cost metrics
  • C: the fastest interface
  • D: one specific router
View Answer
B

Q497: What protocol generates a metric value for each path through the network?
  • A: IP
  • B: TCP
  • C: Dynamic routing protocols
  • D: DHCP
View Answer
C

Q498: What does a routing table store information about?
  • A: Directly connected routes
  • B: Remote routes
  • C: Both A and B
  • D: None of the above
View Answer
C

Q499: What command is used on a Cisco IOS router to display the IPv4 routing table?
  • A: show running-config
  • B: show ip route
  • C: show version
  • D: show interfaces
View Answer
B

Q500: Which type of route is added when an interface is configured and active?
  • A: Static route
  • B: Dynamic route
  • C: Local Route interface
  • D: Remote route
View Answer
C

Test Your Knowledge

Take a timed quiz on Routing and Switching

🚀 Start Quiz Now