Routing and Switching MCQs with Answers
Practice important Routing and Switching MCQs with answers and explanations.
Multiple Choice Questions
Q1761: What does the Dynamic Trunking Protocol (DTP) do?
- A: Converts a link to a trunk link
- B: Configures VLAN IDs
- C: Changes the port to access mode
- D: Specifies the VLAN list
View Answer
A
Q1762: Fill in the blank: To reset a trunk link to its default state, use the command _______.
- A: switchport mode trunk
- B: switchport trunk allowed vlan vlan-list
- C: no switchport trunk
- D: switchport trunk reset
View Answer
C
Q1763: What is the primary purpose of configuring a trunk link between switches?
- A: To carry traffic for multiple VLANs
- B: To restrict VLAN traffic
- C: To connect two switches as access ports
- D: To set up Dynamic Trunking Protocol
View Answer
A
Q1764: Fill in the blank: The switchport mode trunk command makes the port enter into _______ mode.
- A: access
- B: dynamic
- C: trunk
- D: routed
View Answer
C
Q1765: What is the effect of the switchport mode trunk command on the switch port?
- A: It permanently sets the port to trunking mode.
- B: It temporarily sets the port to trunking mode.
- C: It configures the port for dynamic negotiation.
- D: It sets the port to access mode.
View Answer
A
Q1766: Fill in the blank: If a VLAN trunk is reset to its default state, _______ configuration is cleared.
- A: all VLAN
- B: trunking
- C: access
- D: dynamic
View Answer
B
Q1767: What does Dynamic Trunking Protocol (DTP) manage?
- A: IP address assignment
- B: Trunk negotiation
- C: VLAN assignment
- D: Routing protocols
View Answer
B
Q1768: Fill in the blank: DTP operates on a _______ basis between network devices.
- A: one-to-many
- B: many-to-many
- C: point-to-point
- D: broadcast
View Answer
C
Q1769: What command is used to configure a port as a trunk and prevent DTP frames from being generated?
- A: switchport mode trunk
- B: switchport nonegotiate
- C: switchport trunk allowed vlan vlan-list
- D: switchport mode dynamic
View Answer
B
Q1770: To clear the VLAN configuration from a Cisco switch, you use the command _______.
- A: erase startup-config
- B: delete vlan.dat
- C: reload
- D: delete flash
View Answer
B