Routing and Switching MCQs with Answers
Practice important Routing and Switching MCQs with answers and explanations.
Multiple Choice Questions
Q1371: The placement of a standard ACL should aim to:
- A: Allow traffic to reach all networks except where it is filtered
- B: Prevent all traffic from entering the network
- C: Block traffic before it reaches the destination
- D: Apply uniformly across all network devices
View Answer
A
Q1372: What is the first step in creating an ACL?
- A: Enter interface configuration mode
- B: Define statements of what to filter
- C: Apply the ACL to an interface
- D: Enter global configuration mode
View Answer
D
Q1373: To permit a specific host with the IP address 192.168.10.10 in ACL 10, which command is used?
- A: access-list 10 permit 192.168.10.10
- B: access-list 10 permit host 192.168.10.10
- C: access-list 10 permit 192.168.10.0 0.0.0.255
- D: access-list 10 deny 192.168.10.10
View Answer
B
Q1374: What is the purpose of the remark keyword in an ACL?
- A: To create an ACE
- B: To define the ACL number
- C: For documentation and easier understanding
- D: To apply the ACL to an interface
View Answer
C
Q1375: How do you apply an ACL to an interface?
- A: Enter access-list configuration mode
- B: Use the command access-group list-# in
- C: Enter global configuration mode
- D: Define the ACEs in the ACL
View Answer
B
Q1376: What is the range of numbers for standard ACLs in Cisco IOS Software Release 12.0.1?
- A: 1 through 99
- B: 100 through 199
- C: 1 through 255
- D: 1300 to 1999
View Answer
A
Q1377: How many possible standard ACLs can be created with the expanded range?
- A: 99
- B: 798
- C: 255
- D: 999
View Answer
B
Q1378: To permit all IPv4 addresses in the network 192.168.10.0/24 in ACL 10, which command is used?
- A: access-list 10 permit host 192.168.10.0
- B: access-list 10 permit 192.168.10.0 0.0.0.255
- C: access-list 10 deny 192.168.10.0 0.0.0.255
- D: access-list 10 permit 192.168.10.10
View Answer
B
Q1379: What happens if no matches are found in an ACL when the router reaches the end of the list?
- A: Traffic is permitted
- B: Traffic is denied
- C: Traffic is redirected
- D: Traffic is logged
View Answer
B
Q1380: What is the purpose of the access-group command in ACL configuration?
- A: To define the ACL
- B: To apply the ACL to an interface
- C: To remove an ACL
- D: To display the ACL
View Answer
B